0%

Thank you for purchasing your Powder Lite or Full Velocity Muffler from Bikeman Performance Plus. Each lightweight muffler is designed to fit in the stock location on your snowmobile. All Bikeman Performance mufflers are jig-built for consistent and proper fitment. They are also dyno-tested for the best possible power and reliability. Before firing your sled up, make sure the muffler fits correctly and has proper clearance.

 

IMPORTANT - Read the entire instructions before proceeding. If any of it does not make sense or is not in your skillset, please have an experienced technician perform the install.

 

Stock Muffler Removal Instructions

1 - Remove the MAG/Muffler side panel

2 -Remove all springs from the OEM Muffler & remove the muffler

3 - Remove the OEM rubber insulators from the backside of the muffler

4 - This spring tab will help pull the muffler down and hold it in place.

5 - Lastly, install muffler and all springs.

Installation:

1 - Install the OEM rubber insulators or the BMP muffler mount tabs near the back of the muffler.

2 - Tilt the muffler forward in the chassis

3 - Slide back while inserting the muffler outlet into the belly pan hole

4 - Pull the OEM pipe and outlet gasket into the BMP muffler inlet

5 - Spring the BMP muffler to the OEM pipe using the stock springs (Ex.1)

6 - Spring the BMP muffler to the existing spring tab on the steering support brace (Ex.2)

NOTE: Most mufflers do not require any fuel changes. Be sure to consult with us if you find your sled running poorly after installation.

 

Disclaimer

As defined by the Magnuson-Moss Warranty Act. Do not install any performance parts or services unless you have the technical ability to properly set up the entire machine to compensate for the installation of those parts. References in most of our literature to “bolt-on-parts” only indicate the parts are removable from the machine. It is not meant to imply that the parts can be installed without additional modifications. The necessary work and expertise needed to install different product varies. Instructions, where provided, are given to assist in installation only; they are not a substitute for mechanical experience in setting up racing vehicles. References to performance gains, reliability, ease of installation, etc. are bases on our and outside customer’s experiences. This is not a guarantee of similar performance in every installation. While we sell proven products, in the end, it’s up to the individual to make the most of the product. Bikeman Performance Plus is not responsible for any personal or property damages caused by this product.

Tags: muffler install exhaust arctic cat