600R EFI Race Sled Pump Gas Conversion Previous 600R EFI Race Sled Pump Gas Conversion

BMP Polaris Indy/Rush/Switchback/RMK 600 Bolt-On Performer Kit

$1,750.00
Out of stock
SKU
13-303

BMP Polaris Indy/Rush/Switchback/RMK 600 Bolt-On Performer Kit.

This kit requires your stock pipe to be sent in for modification. Turnaround time for the pipe mod is normally 2-3 weeks once we receive your pipe. Please remove your heat shield prior to sending us your pipe. Heat shields not removed will be cut off at BMP and thrown away. If you take the time to un-crimp your heat shield, it can be re-used after your pipe has been modified. Many opt to ceramic coat the pipe to act as a heat shield.

[CLUTCH SET UP SHEET]

Stage 1 Part #: 13-303-1 (Retail $1750)

Stage 3 Part #: 13-303-3 (Retail $2560)

Stage 1

Give that 600 HO motor a wake-up call! In this package, we get 10-12 extra horsepower with a boat load of bottom end and killer acceleration. We start by doing our world-famous pipe mod to give you 5-6 HP. For this mod, we cut your pipe apart and do internal mods to pick up airflow along with external mods to pick up torque. Next, you will install our trick looking billet head kit and add another 3-4 HP. This head kit has removable domes which are available in a low altitude pump gas 12:1 ratio, or a 6000+ ft pump gas setup at 14:1 compression. We then add on a Power Commander 5 EFI control box to fine-tune your fuel map for the kit picking up a few more ponies. This comes pre-loaded with our own custom map, so no tuning is usually required on your end. Lastly, we need to put all that power to the track with a stage 2 clutch kit! Indy, Rush, and Switchback models with the P2 secondary will swap out to the much better Tied secondary setup. The Tied clutch allows for faster acceleration while still improving backshift considerably. RMK models will use the stock TSS-04 secondary loaded with our custom cut helix and spring. All kits will include our Goldstar magnetic adjustable clutch weights and primary spring.

This kit requires your stock pipe to be sent in for modification. Turnaround time for the pipe mod is normally 2-3 weeks once we receive your pipe. Please remove your heat shield prior to sending us your pipe. Heat shields not removed will be cut off at BMP and thrown away. If you take the time to uncrimp your heat shield, it can be re-used after your pipe has been modified. Many opt to ceramic coat the pipe to act as a heat shield.

Stage 3

Want even more power? Send us your cylinders and exhaust valves for our professional cylinder porting and gain 6-7hp extra on top of the stage 1 kit!

[CLUTCH SET UP SHEET]

Write Your Own Review
Write a ReviewBMP Polaris Indy/Rush/Switchback/RMK 600 Bolt-On Performer Kit
To Top